Contact Us

TEL: +86-755-27225419
Mob: +86-13640983275
Address: Building 3th, 6 Th, No.3 Industrial Zone, Da Wang Shan Village, Shajing Town, Bao'an District, Shenzhen, China

Home > Knowledge > Content
Alignment of injection mold
Jan 29, 2018

       Injection molds are designed as two halves, a core half and a cavity half in order to eject the component. For each cycle, the core and cavity are aligned to ensure quality. This alignment is ensured by guide pillar and guide bush. Usually, four guide pillars and guide bushes are used, out of which three pillars are of one diameter and one is of a different diameter, to force the plates into a single configuration (based on the "POKE YOKE" [mistake proof] concept). The register ring has interference fit in top plate and transmission fit with the injection molding machine pattern, aligning the machine pattern and top plate.

Previous: Mold cooling

Next: Ejection system types