Contact Us

TEL: +86-755-27225419
Mob: +86-13640983275
Address: Building 3th, 6 Th, No.3 Industrial Zone, Da Wang Shan Village, Shajing Town, Bao'an District, Shenzhen, China

Home > Knowledge > Content
Influence of mold temperature on injection molding
Jan 23, 2018


          Mold temperature is the most important variable in injection molding - no matter what plastic is injected, it is necessary to ensure the basic wetting of the mold surface.A hot mold surface keeps the plastic surface liquid long enough to form pressure in the cavity.

If the cavity is filled and hardened before the frozen epiderm, the cavity pressure can press the soft plastic onto the metal, then the surface of the cavity is copied.On the other hand, if the plastic that enters the cavity at low pressure is suspended, no matter how short it is, the slight contact with the metal will cause a stain, sometimes referred to as the gate spot.

For each plastic and plastic part, there is a limit on the surface temperature of a mold, which may have one or more adverse effects (for example, components can overflow the edges).Higher mold temperature means lower flow resistance.

In a number of injection molding machine, this natural means faster through the water, the runner and cavity, because the injection flow control valve is not correct the change, filling faster will cause higher in the runner and cavity pressure effectively.It may cause overflows.

Because the hotter model does not freeze the plastic that enters the edge of the overflow area before the high pressure is formed, the melt can spill over the edge of the spout and spill over into the gap.This indicates that there is a need for good injection rate control, and some modern flow control programmers do.

In general, the increase of mold temperature will reduce the condensation of the plastic in the cavity of the cavity, making the molten material flow more easily in the cavity, thus obtaining greater parts weight and better surface quality.At the same time, the increase of mold temperature will increase the tension strength of the parts.

Previous: The difference of Sandblasting and bite flower

Next: The solution of defect of injection molding