Contact Us

TEL: +86-755-27225419
Mob: +86-13640983275
E-mail: sales@hlmold.com.cn
Address: Building 3th, 6 Th, No.3 Industrial Zone, Da Wang Shan Village, Shajing Town, Bao'an District, Shenzhen, China

Home > Knowledge > Content
Scientific versus traditional moulding
Jan 26, 2018



Traditionally, the injection portion of the moulding process was done at one constant pressure to fill and pack the cavity. This method, however, allowed for a large variation in dimensions from cycle-to-cycle. More commonly used now is scientific or decoupled moulding, a method pioneered by RJG Inc. In this the injection of the plastic is "decoupled" into stages to allow better control of part dimensions and more cycle-to-cycle (commonly called shot-to-shot in the industry) consistency. First the cavity is filled to approximately 98% full using velocity (speed) control. Although the pressure should be sufficient to allow for the desired speed, pressure limitations during this stage are undesirable. Once the cavity is 98% full, the machine switches from velocity control to pressure control, where the cavity is "packed out" at a constant pressure, where sufficient velocity to reach desired pressures is required. This allows part dimensions to be controlled to within thousandths of an inch or better


Previous: Moulding toleranc

Next: The cost of injection mold